Dynoman Performance - Austin Texas - Motorcycle Racing Parts

Shop by Model at Dynoman Performance
- CB750 SOHC
- CB750 F2
- CB750/900/1100F
- CB500/550/650
- CB350/400F
- KZ900/1000/GPz
- ZRX1100 / 1200
- GS1000
- GS1100/1150

~ All other bikes please
  choose from the menus

Shop at Dynoman Performance

- CB750/900F/CB1100F
- CB750 SOHC
- CB750 F2
- CB550 / CB500
- KZ900 / 1000
- GS1000
- GS1100

- Camshafts
- Cam Sprockets
- Clutches
- Connecting Rods
- Cylinder Sleeves
- Gasket Sets
- Gaskets,
Head & Base
- Piston Kits
- Rings
- Studs,
Top & Bottom
- Valves
- Valve Train
- More...

- Keihin CR
- Keihin FCR
- Keihin Accessories
- Mikuni RS
- Air Filters
- Push/Pull Throttles
- Vent Filters
- Intake Manifolds
- Dynojet Jet Kits
- Pingel Petcocks
- Carb Sync Tool
- More...

- Dyna 2000
- Dyna S
- Dyna Coils
- Dyna Wires
- NGK Spark Plugs
- Dyna Rev Limiter
- More...

- Kerker / Supertrapp
- Baffles

- Ohlins Shocks
- Progressive Shocks
- Steering Dampers

- EBC Brakes

Shop for motorcycle parts at Dynoman
- Barnett Clutches
- Carrillo Rods
- Cometic Gaskets
- CP Pistons
- Dyna Ignitions
- EBC Brakes
- Falicon Rods
- JE Pistons
- K&N Filters
- Keihin Carbs
- Kerker Headers
- Kibblewhite
- Mikuni Carbs
- NGK Plugs
- Ohlins Shocks
- Pingel Petcocks
- Progressive Shocks
- Vesrah Gaskets
- WebCam Cams
- Wiseco Pistons

Contact Dynoman Performance
- Order Information
- Technical Sheets
- Customer Builds
- Contact


Dyna DRL300 Rev Limiter DRL-400 Rev Limiter
The DRL300 Rev Limiter single stage. The DRL300 can clamp up to 4 of the Dyna blue (low impedance) coils. This means it can be used on drag bikes, and many other applications including automotive HEI ignitions as well as bikes equipped with Dyna S ignitions.

In addition, the output stage has also added a separate kill input. This input works separate of the rev limiter and can function even when the rev limiter has no power. This will kill the spark whenever a 12V signal is applied to the input.

Potential uses include shift kill to kill ignitions during upshift, allowing for clutchless shifts. Instead of having to cut jumper wires to get the box to work with a particular application, and having only two choices, there are now 3 dip switches. These dip switches allow not only for a very wide range of applications (single fire thumpers to Harleys to inline 4s to 8 cylinders), but they also allow for the rev range to be adjusted from the standard 6000-12000. This means that new motorcycles with 12000+ rpm redlines can now be handled, as can applications where the limit needs to be set below 6000.


- Continuously adjustable from 6,000 to 12,000 rpm
- Helps prevent engine failure
- Pre-wired and easy to install
- For use with Dyna S and original equipment ignitions

 - $139.95
+ shipping
Available by special order, please allow 2 to 4 weeks to ship.

The DRL-400 Two-Stage Rev Limiter has been specifically designed to maximize launch performance and over-rev protection in drag racing. It allows precisely controlled launch RPM limit to be set, while also guaranteeing against over-rev damage due to missed shifts or drive train breakage.

DRL-400 Features:
- Accurate launch limiting with 32 different settings
- Smooth, non-destructive launch limiting
- Adjustable high limit between 16 different settings

 - $239.95 + shipping
Available by special order, please allow 2 to 4 weeks to ship.
- Same as above but for bikes with CDI
   type ignitions only

- Dyna suggested retail $142.99
- Limited to supply on hand!

$89.95 + shipping




For your security and ours, we process
our payments
through Paypal.
PayPal Logo
PayPal Acceptance Mark

2000-17 DynomanPerformance.com
All rights reserved. Prices, descriptions, and products subject to change without notice.